My Sony Z3 compact got bricked after flashing firmware using flashtool. The phone won't turn on, no vibration or any sign of life on display, i have tried to hard reset by pressing small yellow button next to the simcard slot but with no luck. When i connect it to PC or charger red led light shows up for 2 sec and then it's gone. When i connect the phone with battery i see this in device manager USB COMPLANT HID - I can't get the phone to boot in fastboot by pressing power+vol up or flashmode by pressing power+vol down, so i am not able to use flashtool, pc companion or emma - the phone is just not detected. When i connect it without battery and without gordons gate driver i see in device manager QHSUSB_BULK, but when i install the gordons gate driver i see SEMC Flash device. So i figured out that i have to flash it using s1tool app in S1 emergengency mode... but when i try to do that with s1tool (version 06.02.2015 ) i got an error HARDWARE ID NOT SUPPORTED.
Is there any way of unbricking my phone, maybe with xFLASHER or some other app that can support my phone ? Please help.
Or i have to buy SEtool box in order to flash the phone with SEtool 2 app ...
Attached Files
-
usbhuman.JPG 144.78K
6 downloads
-
qhsusb_bulk.JPG 145.94K
4 downloads
-
SEMC FLASH DEVICE.JPG 153.82K
4 downloads
-
ERROR HARDWARE ID NOT SUPPORTED.JPG 168.3K
3 downloads
Edited by ivan131313, 24 September 2015 - 17:38.
If phone can't be identified - only authorized Sony service centre (warranty repair) or main board swap may help. S1tool does not support Xperia Z3 / Z3 compact at all.
